beautypg.com

H3C Technologies H3C S10500 Series Switches User Manual

Page 53

background image

42

# Bind VLAN-interface 10 with VPN instance vpn1, and configure an IPv6 address for the VLAN

interface.

[MCE] interface vlan-interface 10

[MCE-Vlan-interface10] ip binding vpn-instance vpn1

[MCE-Vlan-interface10] ipv6 address 2001:1::1 64

[MCE-Vlan-interface10] quit

# Configure VLAN 20, add port GigabitEthernet1/0/2 to VLAN 20, bind VLAN-interface 20 with VPN
instance vpn2, and assign an IPv6 address to VLAN-interface 20.

[MCE] vlan 20

[MCE-vlan20] port gigabitethernet 1/0/2

[MCE-vlan20] quit

[MCE] interface vlan-interface 20

[MCE-Vlan-interface20] ip binding vpn-instance vpn2

[MCE-Vlan-interface20] ipv6 address 2002:1::1 64

[MCE-Vlan-interface20] quit

# On PE 1, configure VPN instances vpn1 and vpn2, and specify an RD and VPN targets for each VPN
instance.

system-view

[PE1] ip vpn-instance vpn1

[PE1-vpn-instance-vpn1] route-distinguisher 30:1

[PE1-vpn-instance-vpn1] vpn-target 10:1

[PE1-vpn-instance-vpn1] quit

[PE1] ip vpn-instance vpn2

[PE1-vpn-instance-vpn2] route-distinguisher 40:1

[PE1-vpn-instance-vpn2] vpn-target 20:1

[PE1-vpn-instance-vpn2] quit

2.

Configure routing between the MCE and VPN sites.

The MCE is connected with VPN 1 directly, and no routing protocol is enabled in VPN 1. Therefore, you

can configure IPv6 static routes.
# On VR 1, assign IP address 2001:1::2/64 to the interface connected to the MCE and 2012:1::2/64 to

the interface connected to VPN 1. Add ports to VLANs. (Details not shown)
# On VR 1, configure a default route, specifying the next hop as 2001:1::1.

system-view

[VR1] ipv6 route-static :: 0 2001:1::1

# On the MCE, configure an IPv6 static route to 2012:1::/64, specify the next hop as 2001:1::2, and bind
the static route with VPN instance vpn1.

[MCE] ipv6 route-static vpn-instance vpn1 2012:1:: 64 vpn-instance vpn1 2001:1::2

# Run RIPng in VPN 2. Configure RIPng process 20 for VPN instance vpn2 on the MCE, so that the MCE
can learn the routes of VPN 2 and add them to the routing table of VPN instance vpn2.
# Configure RIPng process 20, binding it with VPN instance vpn2.

[MCE] ripng 20 vpn-instance vpn2

# Advertise subnet 2002:1::/64 through RIPng.

[MCE] interface vlan-interface 20

[MCE-Vlan-interface20] ripng 20 enable

[MCE-Vlan-interface20] quit