H3C Technologies H3C S10500 Series Switches User Manual

Page 191

180

# Configure basic MPLS.

system-view

[Sysname] sysname NPE1

[NPE1] interface loopback 0

[NPE1-LoopBack0] ip address 2.2.2.2 32

[NPE1-LoopBack0] quit

[NPE1] mpls lsr-id 2.2.2.2

[NPE1] mpls

[NPE1–mpls] quit

[NPE1] mpls ldp

[NPE1–mpls-ldp] quit

# Configure an IP address for the interface connected to UPE, and enable MPLS and MPLS LDP.

[NPE1] interface vlan-interface 12

[NPE1-Vlan-interface12] ip address 12.1.1.2 24

[NPE1-Vlan-interface12] mpls

[NPE1-Vlan-interface12] mpls ldp

[NPE1-Vlan-interface12] quit

# Configure an IP address for the interface connected to NPE 3, and enable MPLS and MPLS LDP.

[NPE1] interface vlan-interface 15

[NPE1-Vlan-interface15] ip address 15.1.1.1 24

[NPE1-Vlan-interface15] mpls

[NPE1-Vlan-interface15] mpls ldp

[NPE1-Vlan-interface15] quit

# Configure the remote LDP peer UPE.

[NPE1] mpls ldp remote-peer 2

[NPE1-mpls-remote-2] remote-ip 1.1.1.1

[NPE1-mpls-remote-2] quit

# Configure the remote LDP peer NPE 3.

[NPE1] mpls ldp remote-peer 3

[NPE1-mpls-remote-3] remote-ip 4.4.4.4

[NPE1-mpls-remote-3] quit

# Enable L2VPN and MPLS L2VPN.

[NPE1] l2vpn

[NPE1-l2vpn] mpls l2vpn

[NPE1-l2vpn] quit

# Configure the basic attributes of VPLS instance aaa, which uses LDP.

[NPE1] vsi aaa static

[NPE1-vsi-aaa] pwsignal ldp

[NPE1-vsi-aaa-ldp] vsi-id 500

[NPE1-vsi-aaa-ldp] peer 1.1.1.1 upe

[NPE1-vsi-aaa-ldp] peer 4.4.4.4

[NPE1-vsi-aaa-ldp] quit

[NPE1-vsi-aaa] quit

The configuration procedure on NPE 2 is similar to that on NPE 1. (Details not shown)

Configure NPE 3.