H3C Technologies H3C S10500 Series Switches - Manual (Page 136)

125
MPLS TE configuration examples
MPLS TE using static CR-LSP configuration example
Network requirements
• Switch A, Switch B, and Switch C run IS-IS.
• Establish a TE tunnel using a static CR-LSP between Switch A and Switch C.
Figure 31 Set up MPLS TE tunnels using static CR-LSPs
Loop0
2.2.2.2/32
Vlan-int1
2.1.1.2/24
Vlan-int2
3.2.1.1/24
Vlan-int1
2.1.1.1/24 Vlan-int2
3.2.1.2/24
Loop0
1.1.1.1/32
Loop0
3.3.3.3/32
Switch A Switch C
Switch B
Configuration procedure
1. Assign IP addresses and masks to interfaces (see Figure 31 ) (details not shown)
2. Enable IS-IS to advertise host routes with LSR IDs as destinations
# Configure Switch A.
system-view
[SwitchA] isis 1
[SwitchA-isis-1] network-entity 00.0005.0000.0000.0001.00
[SwitchA-isis-1] quit
[SwitchA] interface vlan-interface 1
[SwitchA-Vlan-interface1] isis enable 1
[SwitchA-Vlan-interface1] quit
[SwitchA] interface loopback 0
[SwitchA-LoopBack0] isis enable 1
[SwitchA-LoopBack0] quit
# Configure Switch B.
system-view
[SwitchB] isis 1
[SwitchB-isis-1] network-entity 00.0005.0000.0000.0002.00
[SwitchB-isis-1] quit
[SwitchB] interface vlan-interface 1
[SwitchB-Vlan-interface1] isis enable 1
[SwitchB-Vlan-interface1] quit