beautypg.com

Configuring the remote peer – H3C Technologies H3C S10500 Series Switches User Manual

Page 207

background image

196

Configure basic MPLS and MPLS LDP on the PEs and P devices to establish LDP LSPs.

Enable MPLS L2VPN on the PEs.

To configure Martini MPLS L2VPN, you need the following data:

Types and numbers of the interfaces connecting the CEs

Destination address of the L2VPN connection and the PW ID, or, VC ID

PW class template

Configuring the remote peer

Follow these steps to configure the remote peer for a PE:

To do…

Use the command…

Remarks

Enter system view

system-view

mpls ldp remote-peer
remote-peer-name

Required

Configure the remote peer

remote-ip ip-address

Required

NOTE:

For remote peer configuration information, see the chapter ”MPLS basics configuration.”

Creating a Martini MPLS L2VPN connection on a Layer 3

interface

Follow these steps to create a Martini MPLS L2VPN connection on a Layer 3 interface of a PE:

To do…

Use the command…

Remarks

Enter system view

system-view

Enter the view of the interface
connecting the CE

interface interface-type
interface-number

Create a Martini MPLS L2VPN
connection

mpls l2vc destination vcid
[ { control-word | ethernet |

no-control-word | vlan } |

[ tunnel-policy
tunnel-policy-name ] ] *

Required

CAUTION:

A Martini connection has two main parameters: IP address of the peer PE, and VC ID. The combination of
the VC ID and the encapsulation type must be unique on a PE. Changing the encapsulation type may result

in VC ID conflicts.

Creating a Martini MPLS L2VPN connection for a service
instance

To complete this task, perform the following configurations on a PE:

Create a service instance on an Layer 2 Ethernet interface