H3C Technologies H3C S10500 Series Switches User Manual

Page 188

177

# Configure the basic attributes of VPLS instance aaa, which uses LDP.

[PE2] vsi aaa static

[PE2-vsi-aaa] pwsignal ldp

[PE2-vsi-aaa-ldp] vsi-id 500

[PE2-vsi-aaa-ldp] peer 1.1.1.9

[PE2-vsi-aaa-ldp] quit

[PE2-vsi-aaa] quit

# Configure the basic attributes of VPLS instance bbb, which uses BGP.

[PE2] vsi bbb auto

[PE2-vsi-bbb] pwsignal bgp

[PE2-vsi-bbb-bgp] route-distinguisher 100:1

[PE2-vsi-bbb-bgp] vpn-target 111:1

[PE2-vsi-bbb-bgp] site 20

[PE2-vsi-bbb-bgp] quit

[PE2-vsi-bbb] quit

# On the interface connecting CE 2, create service instance 1000 and bind it with VPLS instance aaa,
and create service instance 2000 and bind it with VPLS instance bbb.

[PE2] interface gigabitethernet 1/0/1

[PE2-GigabitEthernet1/0/1] service-instance 1000

[PE2-GigabitEthernet1/0/1-srv1000] encapsulation s-vid 100

[PE2-GigabitEthernet1/0/1-srv1000] xconnect vsi aaa

[PE2-GigabitEthernet1/0/1-srv1000] quit

[PE2-GigabitEthernet1/0/1] service-instance 2000

[PE2-GigabitEthernet1/0/1-srv2000] encapsulation s-vid 200

[PE2-GigabitEthernet1/0/1-srv2000] xconnect vsi bbb

[PE2-GigabitEthernet1/0/1-srv2000] quit

[PE2-GigabitEthernet1/0/1] quit

Verify the configuration

After completing previous configurations, issue the display vpls connection command on the PEs. The

output shows that a PW connection in up state has been established. Take PE 2 as an example:

[PE2] display vpls connection vsi aaa verbose

VSI Name: aaa Signaling: ldp

**Remote Vsi ID : 500

VC State : up

Encapsulation : vlan

Group ID : 0

MTU : 1500

Peer Ip Address : 1.1.1.9

PW Type : label

Local VC Label : 89766

Remote VC Label : 81922

Link ID : 1

Tunnel Policy : --

Tunnel ID : 0x4600068