beautypg.com

Configuration procedure, Creating an mpls te tunnel over a static cr-lsp – H3C Technologies H3C S10500 Series Switches User Manual

Page 109

background image

98

Configure basic MPLS.

NOTE:

For configuration information about MPLS basic capability, see the chapter “MPLS basics configuration.”

Configuration procedure

Follow these steps to configure basic MPLS TE:

To do…

Use the command…

Remarks

Enter system view

system-view

––

Enter MPLS view

mpls

––

Enable global MPLS TE

mpls te

Required
Disabled by default

Return to system view

quit

––

Enter the interface view of an MPLS
TE link

interface interface-type
interface-number

––

Enable interface MPLS TE

mpls te

Required
Disabled by default

Return to system view

quit

––

Create a tunnel interface and enter
its view

interface tunnel tunnel-number

Required

Assign an IP address to the tunnel
interface

ip address ip-address netmask

Optional

Set the tunnel protocol to MPLS TE tunnel-protocol mpls te

Required

Configure the destination address
of the tunnel

destination ip-address

Required

Configure the tunnel ID of the
tunnel

mpls te tunnel-id tunnel-id

Required

Submit the current tunnel
configuration

mpls te commit

Required

NOTE:

For information about tunnel interfaces, see

Layer 3—IP Services Configuration Guide.

Creating an MPLS TE Tunnel over a static CR-LSP

Creating MPLS TE tunnels over static CR-LSPs does not involve configuration of tunnel constraints or the

issue of IGP TE extension or CSPF. Create a static CR-LSP and a TE tunnel using static signaling and then

associate them.
Despite its ease of configuration, the application of MPLS TE tunnels over static CR-LSPs is restricted
because they cannot dynamically adapt to network changes.