beautypg.com

Configuration procedure, Establishing dynamic lsps through ldp, Configuring mpls ldp capability – H3C Technologies H3C S10500 Series Switches User Manual

Page 69: Establishing dynamic lsps, Through ldp

background image

58

Configuration procedure

Follow these steps to configure a static LSP:

To do…

Use the command…

Remarks

Enter system view

system-view

Configure a static LSP taking the
current LSR as the ingress

static-lsp ingress lsp-name
destination dest-addr mask |

mask-length } { nexthop

next-hop-addr | out-label out-label

Required

Configure a static LSP taking the
current LSR as a transit LSR

static-lsp transit lsp-name
incoming-interface interface-type
interface-number
in-label in-label

nexthop next-hop-addr out-label

out-label

Required

Configure a static LSP taking the
current LSR as the egress

static-lsp egress lsp-name
incoming-interface interface-type

interface-number in-label in-label

Required

NOTE:

When you configure a static LSP on the ingress LSR, the next hop specified must be consistent with the
next hop of the optimal route in the routing table. If you configure a static IP route for the LSP, you must

specify the same next hop for the static route and the static LSP.

For an ingress or transit LSR, do not specify the public address of an interface on the LSR as the next hop
address.

For information about configuring a static IP route, see

Layer 3—IP Routing Configuration Guide.

Establishing dynamic LSPs through LDP

Configuring MPLS LDP capability

Follow these steps to configure MPLS LDP capability:

To do…

Use the command…

Remarks

Enter system view

system-view

Enable LDP capability globally and
enter MPLS LDP view

mpls ldp

Required
Not enabled by default

Configure the LDP LSR ID

lsr-id lsr-id

Optional
MPLS LSR ID of the LSR by default

Return to system view

quit

Enter interface view

interface interface-type
interface-number

Enable LDP capability for the
interface

mpls ldp

Required
Not enabled by default