beautypg.com

H3C Technologies H3C S10500 Series Switches User Manual

Page 161

background image

150

Backup Tunnel : -

Group Status : -

Oam Status : -

NOTE:

If you perform the display mpls te tunnel-interface command immediately after an FRR protection switch,
you are likely to see two CR-LSPs in up state are present. This is normal because the make-before-break

mechanism of FRR introduces a delay before removing the old LSP after a new LSP is created.

Perform the display mpls lsp verbose command on Switch B. You can see that the bypass tunnel is in use.

[SwitchB] display mpls lsp verbose

------------------------------------------------------------------

LSP Information: RSVP LSP

------------------------------------------------------------------

No : 1

IngressLsrID : 1.1.1.1

LocalLspID : 1

Tunnel-Interface : Tunnel4

Fec : 4.4.4.4/32

Nexthop : 3.1.1.2

In-Label : 1024

Out-Label : 1024

In-Interface : Vlan-interface1

Out-Interface : Vlan-interface2

LspIndex : 4097

Tunnel ID : 0x22001

LsrType : Transit

Bypass In Use : In Use

BypassTunnel : Tunnel Index[Tunnel5], InnerLabel[1024]

Mpls-Mtu : 1500

No : 2

IngressLsrID : 2.2.2.2

LocalLspID : 1

Tunnel-Interface : Tunnel5

Fec : 3.3.3.3/32

Nexthop : 3.2.1.2

In-Label : NULL

Out-Label : 1024

In-Interface : ----------

Out-Interface : Vlan-interface4

LspIndex : 4098

Tunnel ID : 0x22002

LsrType : Ingress

Bypass In Use : Not Exists

BypassTunnel : Tunnel Index[---]

Mpls-Mtu : 1500

# Set the FRR polling timer to five seconds on PLR.