Configuring ospfv3 – H3C Technologies H3C S10500 Series Switches User Manual
Page 48

37
To do…
Use the command…
Remarks
Create a RIPng process for
an IPv6 VPN instance and
enter RIPng view
ripng [ process-id ] vpn-instance
vpn-instance-name
Required
Redistribute the VPN routes
import-route protocol [ process-id ]
[ allow-ibgp ] [ cost cost | route-policy
route-policy-name ] *
Required
By default, no route of any
other routing protocol is
redistributed into RIPng.
Configure the default cost
value for the redistributed
routes
default cost value
Optional
0 by default
Return to system view
quit
—
Enter interface view
interface interface-type interface-number
—
Enable the RIPng process on
the interface
ripng process-id enable
Required
Disabled by default.
NOTE:
For more information about RIPng, see
Layer 3—IP Routing Configuration Guide.
Configuring OSPFv3
Follow these step to configure OSPFv3 between MCE and PE:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Create an OSPFv3
process for an IPv6
VPN instance and enter
OSPFv3 view
ospfv3 [ process-id ] vpn-instance
vpn-instance-name
Required
Set the router ID
router-id router-id
Required
Redistribute the VPN
routes
import-route protocol [ process-id |
allow-ibgp ] [ cost value | route-policy
route-policy-name | type type ] *
Required
By default, no route of any other routing
protocol is redistributed into OSPFv3.
Configure a filtering
policy to filter the
redistributed routes
filter-policy { acl6-number | ipv6-prefix
ipv6-prefix-name } export [ bgp4+ |
direct | isisv6 process-id | ospfv3
process-id | ripng process-id | static ]
Optional
By default, redistributed routes are not
filtered.
Return to system view
quit
—
Enter interface view
interface interface-type
interface-number
—
Enable the OSPFv3
process on the
interface
ospfv3 process-id area area-id
[ instance instance-id ]
Required
Disabled by default.
NOTE:
For more information about OSPFv3, see
Layer 3—IP Routing Configuration Guide.