Network requirements – H3C Technologies H3C S10500 Series Switches User Manual
Page 220

209
# On the interface connected to CE 2, create an SVC MPLS L2VPN connection. The interface requires no
IP address.
[PE2] interface vlan-interface 10
[PE2-Vlan-interface10] mpls static-l2vc destination 192.2.2.2 transmit-vpn-label 200
receive-vpn-label 100
[PE2-Vlan-interface10] quit
5.
Configure CE 2.
[Sysname] sysname CE2
[CE2] interface vlan-interface 10
[CE2-Vlan-interface10] ip address 100.1.1.2 24
6.
Verify your configuration.
Display SVC L2VPN connection information on PE 1 or PE 2. The output shows that an L2VPN connection
has been established.
# Display SVC L2VPN connection information on PE 1.
[PE1] display mpls static-l2vc
Total connections: 1, 1 up, 0 down
ce-intf state destination tr-label rcv-label tnl-policy
Vlan10 up 192.3.3.3 100 200 default
# Display SVC L2VPN connection information on PE 2.
[PE2] display mpls static-l2vc
Total connections: 1, 1 up, 0 down
ce-intf state destination tr-label rcv-label tnl-policy
Vlan20 up 192.2.2.2 200 100 default
# Ping CE 2 from CE 1. The output shows that CE 1 and CE 2 can ping each other.
[CE1] ping 100.1.1.2
PING 100.1.1.2: 56 data bytes, press CTRL_C to break
Reply from 100.1.1.2: bytes=56 Sequence=1 ttl=255 time=150 ms
Reply from 100.1.1.2: bytes=56 Sequence=2 ttl=255 time=130 ms
Reply from 100.1.1.2: bytes=56 Sequence=3 ttl=255 time=130 ms
Reply from 100.1.1.2: bytes=56 Sequence=4 ttl=255 time=140 ms
Reply from 100.1.1.2: bytes=56 Sequence=5 ttl=255 time=80 ms
--- 100.1.1.2 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 80/126/150 ms
Example for configuring Martini MPLS L2VPN on VLAN
interfaces
Network requirements
CEs are connected to PEs through VLAN interfaces.
A Martini MPLS L2VPN is established between CE 1 and CE 2.