H3C Technologies H3C S10500 Series Switches User Manual
Page 147

136
[SwitchB-Vlan-interface1] quit
[SwitchB] interface vlan-interface 2
[SwitchB-Vlan-interface2] mpls
[SwitchB-Vlan-interface2] mpls te
[SwitchB-Vlan-interface2] mpls rsvp-te
[SwitchB-Vlan-interface2] mpls rsvp-te hello
[SwitchB-Vlan-interface2] quit
# Configure Switch C.
[SwitchC] mpls lsr-id 3.3.3.9
[SwitchC] mpls
[SwitchC-mpls] mpls te
[SwitchC-mpls] mpls rsvp-te
[SwitchC-mpls] mpls rsvp-te hello
[SwitchC-mpls] quit
[SwitchC] interface vlan-interface 2
[SwitchC-Vlan-interface2] mpls
[SwitchC-Vlan-interface2] mpls te
[SwitchC-Vlan-interface2] mpls rsvp-te
[SwitchC-Vlan-interface2] mpls rsvp-te hello
[SwitchC-Vlan-interface2] quit
4.
Configure IS-IS TE (details not shown)
5.
Configure the MPLS TE tunnel (details not shown)
6.
Configure RSVP-TE GR
# Configure Switch A.
[SwitchA] mpls
[SwitchA-mpls] mpls rsvp-te graceful-restart
# Configure Switch B.
[SwitchB] mpls
[SwitchB-mpls] mpls rsvp-te graceful-restart
# Configure Switch C.
[SwitchC] mpls
[SwitchC-mpls] mpls rsvp-te graceful-restart
7.
Verify the configuration
# After the configuration, a tunnel is created between Switch A and Switch C. Issuing the following
command, you will see that the neighbor’s GR status is Ready.
Interface Vlan-interface1
Neighbor Addr: 10.1.1.2
SrcInstance: 880 NbrSrcInstance: 5017
PSB Count: 0 RSB Count: 1
Hello Type Sent: REQ Neighbor Hello Extension: ENABLE
SRefresh Enable: NO