H3C Technologies H3C S10500 Series Switches - Manual (Page 198)

187
Troubleshooting VPLS
Symptom:
The VPLS PW is not up.
Analysis:
• The public network LSP tunnel is not established.
• The extended session is not working normally.
• A private network interface is not bound with the corresponding VPLS instance or the private
network interface is not up.
Solution:
• Check the routing tables of the PEs to see whether a route is available between the two PEs. Check
whether each device can ping the loopback interface of the peer and whether the LDP session is
normal.
• Check whether any extended session configuration command is missing at either side.
• View the private interface status by using the display interface command. Make sure the private
interface is up.
• View the current configuration by using the display current-configuration command. Make sure that
the two peers have the same PW ID and transport mode.