beautypg.com

H3C Technologies H3C S10500 Series Switches User Manual

Page 149

background image

138

[SwitchB-Vlan-interface12] quit

2.

Configure OSPF

# Configure Switch A.

[SwitchA] ospf

[SwitchA-ospf-1] area 0

[SwitchA-ospf-1-area-0.0.0.0] network 12.12.12.1 0.0.0.255

[SwitchA-ospf-1-area-0.0.0.0] network 1.1.1.1 0.0.0.0

[SwitchA-ospf-1-area-0.0.0.0] quit

[SwitchA-ospf-1] quit

# Configure Switch B.

[SwitchB] ospf

[SwitchB-ospf-1] area 0

[SwitchB-ospf-1-area-0.0.0.0] network 12.12.12.2 0.0.0.255

[SwitchB-ospf-1-area-0.0.0.0] network 2.2.2.2 0.0.0.0

[SwitchB-ospf-1-area-0.0.0.0] quit

[SwitchB-ospf-1] quit

3.

Configure IP addresses for the interfaces

# Configure Switch A.

[SwitchA] interface vlan-interface 12

[SwitchA-Vlan-interface12] ip address 12.12.12.1 24

[SwitchA-Vlan-interface12] quit

# Configure Switch B.

[SwitchB] interface vlan-interface 12

[SwitchB-Vlan-interface12] ip address 12.12.12.2 24

4.

Configure the MPLS TE tunnel

# Configure an RSVP-TE tunnel between Switch A and Switch B.

[SwitchA] interface tunnel 1

[SwitchA-Tunnel1] ip address 10.10.10.1 24

[SwitchA-Tunnel1] tunnel-protocol mpls te

[SwitchA-Tunnel1] destination 2.2.2.2

[SwitchA-Tunnel1] mpls te tunnel-id 10

[SwitchA-Tunnel1] mpls te signal-protocol rsvp-te

[SwitchA-Tunnel1] mpls te commit

[SwitchA-Tunnel1] return

5.

Verify the configuration

# On Switch A, display the detailed information about the BFD session between Switch A and Switch B.

display bfd session verbose

Total Session Num: 1 Init Mode: Active

Session Working Under Ctrl Mode:

Local Discr: 21 Remote Discr: 20

Source IP: 12.12.12.1 Destination IP: 12.12.12.2

Session State: Up Interface: Vlan-interface12