beautypg.com

Protocols and standards, Mpls te configuration task list, Configuring basic mpls te – H3C Technologies H3C S10500 Series Switches User Manual

Page 108: Configuration prerequisites

background image

97

one that has a lower priority, you must first configure the clear action and then configure the new

switching action.

Protocols and standards

RFC 2702, Requirements for Traffic Engineering Over MPLS

RFC 3212, Constraint-Based LSP Setup using LDP

RFC 2205, Resource ReSerVation Protocol

RFC 3209, RSVP-TE: Extensions to RSVP for LSP Tunnels

RFC 2961, RSVP Refresh Overhead Reduction Extensions

RFC 3564, Requirements for Support of Differentiated Service-aware MPLS Traffic Engineering

ITU-T Recommendation Y.1720, Protection switching for MPLS networks

MPLS TE configuration task list

Complete the following tasks to configure MPLS TE:

Task

Remarks

Configuring basic MPLS TE

Required

Creating an MPLS TE Tunnel over a static CR-LSP

Configuring an

MPLS TE tunnel

Creating an MPLS TE tunnel with a dynamic signaling protocol

Required
Use either approach

Configuring RSVP-TE advanced features

Optional

Tuning CR-LSP setup

Optional

Tuning MPLS TE tunnel setup

Optional

Forwarding traffic along MPLS TE tunnels

using static routes

Configuring traffic forwarding

Forwarding traffic along MPLS TE tunnels
through automatic route advertisement

Required
Use any approach

Configuring traffic forwarding tuning parameters

Optional

Configuring CR-LSP backup

Optional

Configuring FRR

Optional

Inspecting an MPLS TE tunnel

Optional

Configuring protection switching

Optional

Configuring basic MPLS TE

This configuration task includes the basic configurations required for all MPLS TE features.

Configuration prerequisites

Before you configure the basic MPLS TE, complete the following tasks:

Configure static routing or IGPs to make sure all LSRs are reachable.