H3C Technologies H3C S10500 Series Switches User Manual
Page 139

128
Output queue : (Protocol queuing : Size/Length/Discards) 0/500/0
Output queue : (FIFO queuing : Size/Length/Discards) 0/75/0
Last 300 seconds input: 0 bytes/sec, 0 packets/sec
Last 300 seconds output: 0 bytes/sec, 0 packets/sec
0 packets input, 0 bytes
0 input error
0 packets output, 0 bytes
0 output error
Perform the display mpls te tunnel command on each switch to verify information about the MPLS TE
tunnel.
[SwitchA] display mpls te tunnel
LSP-Id Destination In/Out-If Name
1.1.1.1:1 3.3.3.3 -/Vlan1 Tunnel0
[SwitchB] display mpls te tunnel
LSP-Id Destination In/Out-If Name
- - Vlan1/Vlan2 Tunnel0
[SwitchC] display mpls te tunnel
LSP-Id Destination In/Out-If Name
- - Vlan2/- Tunnel0
Perform the display mpls lsp command or the display mpls static-cr-lsp command on each switch to
verify information about the static CR-LSP.
[SwitchA] display mpls lsp
-------------------------------------------------------------------
LSP Information: STATIC CRLSP
-------------------------------------------------------------------
FEC In/Out Label In/Out IF Vrf Name
3.3.3.3/32 NULL/20 -/Vlan1
[SwitchB] display mpls lsp
------------------------------------------------------------------
LSP Information: STATIC CRLSP
------------------------------------------------------------------
FEC In/Out Label In/Out IF Vrf Name
-/- 20/30 Vlan1/Vlan2
[SwitchC] display mpls lsp
------------------------------------------------------------------
LSP Information: STATIC CRLSP
------------------------------------------------------------------
FEC In/Out Label In/Out IF Vrf Name
-/- 30/NULL Vlan1/-
[SwitchA] display mpls static-cr-lsp
total statics-cr-lsp : 1
Name FEC I/O Label I/O If State
Tunnel0 3.3.3.3/32 NULL/20 -/Vlan1 Up
[SwitchB] display mpls static-cr-lsp
total statics-cr-lsp : 1
Name FEC I/O Label I/O If State
Tunnel0 -/- 20/30 Vlan1/Vlan2 Up
[SwitchC] display mpls static-cr-lsp