beautypg.com

Configuring bgp vpls, Configuration prerequisites, Configuring the bgp extension – H3C Technologies H3C S10500 Series Switches User Manual

Page 180: Enabling l2vpn and mpls l2vpn

background image

169

To do…

Use the command…

Remarks

Configure a packet matching rule
for the service instance

encapsulation { { c-vid | s-vid }
{ vlan-id | vlan-list } [ only-tagged ]
| port-based | s-vid vlan-id c-vid

{ vlan-list | all } | tagged |

untagged }

Required
By default, no packet matching

rule is configured for a service

instance.

Associate the service instance with
a VPLS instance

xconnect vsi vsi-name
[ access-mode { ethernet | vlan } ] *

Required
By default, a service instance is not

associated with any VPLS instance.

Configuring BGP VPLS

Configuration prerequisites

Before you configure BGP VPLS, complete the following tasks:

Configure an IGP on the MPLS backbone devices (PEs and P devices) to guarantee the IP
connectivity of the MPLS backbone. For configuration information, see Layer 3—IP Routing

Configuration Guide.

Configure basic MPLS on the MPLS backbone devices (PEs and P devices) to establish LSP tunnels
on the backbone network. For configuration information, see the chapter “MPLS basics

configuration.”

Configuring the BGP extension

Before configuring BGP VPLS, you must configure BGP parameters on the PEs. For configuration details,

see Layer 3—IP Routing Configuration Guide.
Follow these steps to configure BGP extension:

To do…

Use the command…

Remarks

Enter system view

system-view

Enter BGP view

bgp as-number

Enter VPLS address family view

vpls-family

Required

Activate a peer

peer peer-address enable

Required
No peer is activated by default.

NOTE:

For configurations in VPLS address family view, see the chapter “MPLS L3VPN configuration.”

Enabling L2VPN and MPLS L2VPN

Enable L2VPN and MPLS L2VPN before you configure VPLS related configurations.
Follow these steps to enable L2VPN and MPLS L2VPN: