beautypg.com

Configuring cr-lsp reoptimization, Tuning mpls te tunnel setup – H3C Technologies H3C S10500 Series Switches User Manual

Page 120

background image

109

The affinity of an MPLS TE tunnel is configured at the first node on the tunnel and then signaled to the rest

nodes through RSVP-TE.

NOTE:

The associations between administrative groups and affinities may vary by vendor. To ensure the
successful establishment of a tunnel between two devices from different vendors, correctly configure their
respective administrative groups and affinities.

Follow these steps to configure the administrative group and affinity attribute:

To do…

Use the command...

Remarks

Enter system view

system-view

––

Enter interface view of MPLS TE link

interface interface-type
interface-number

––

Assign the link to a link
administrative group

mpls te link administrative group
value

Optional
The default is 0x00000000.

Exit to system view

quit

––

Enter MPLS TE tunnel interface view interface tunnel tunnel-number ––

Configure the affinity attribute of
the MPLS TE tunnel

mpls te affinity property properties
[ mask mask-value ]

Optional
The default affinity attribute is
0x00000000, and the default

mask is 0x00000000.

Submit current tunnel configuration mpls te commit

Required

Configuring CR-LSP reoptimization

Dynamic CR-LSP optimization involves the periodic calculation of paths that traffic trunks traverse. If a

better route is found for an existing CR-LSP, a new CR-LSP is established to replace the old one, and

services are switched to the new CR-LSP.
Follow these steps to configure CR-LSP reoptimization:

To do…

Use the command...

Remarks

Enter system view

system-view

––

Enter MPLS TE tunnel interface view

interface tunnel tunnel-number ––

Enable reoptimization for the MPLS TE
tunnel

mpls te reoptimization [ frequency
seconds ]

Required
Disabled by default

Submit current tunnel configuration

mpls te commit

Required

Exit to user view

return

––

Perform reoptimization on all MPLS TE
tunnels with reoptimization enabled

mpls te reoptimization

Optional

Tuning MPLS TE tunnel setup

This section only covers the configuration tasks for tuning MPLS TE tunnel setup.