2 power requirements, Figure 2-3, Hot spot power entry module – Artesyn Centellis 4100 Installation and Use (2015) User Manual
Page 70: Figure "hot spot power entry module
Site Preparation
Centellis 4100 Installation and Use (6806800D82E)
72
2.2.3.2
Power Requirements
Make sure that a suitable -40.0 to -72VDC power source is within reach of the system. Four
power entry modules (PEMs) can be installed in the system.
Figure 2-3
Hot Spot Power Entry Module
Personal Injury or System Damage
The system is supplied by a TNV-2 voltage. This voltage is considered hazardous.
Make sure that the external power supply meets the relevant safety standards. Ensure that
TNV-2 is separated from dangerous voltages (mains) through double or reinforced
insulation.
This manual is related to the following products:
- AXP640 Installation and Use (April 2015) AXP1620 Installation and Use (August 2014) AXP1620 Installation and Use (September 2014) Centellis-4440/AXP-1440 Installation and Use (August 2014) Centellis-4440/AXP-1440 Installation and Use (July 2014) AXP1620 Installation and Use (May 2014) Centellis-4440/AXP1440 Installation and Use (August 2014) Centellis-4440/AXP-1440 Installation and Use (May 2014) Centellis-4440/AXP1440 Installation and Use (September 2014) AXP640 Installation and Use (May 2014)