Artesyn Centellis 4100 Installation and Use (2015) - Manual (Page 21)

Safety Notes
Centellis 4100 Installation and Use (6806800D82E) 23
System Installation
System Damage
To avoid system damage verify that the system environment meets the environmental and
power requirements given in this manual before installing the system.
Before you begin to set up and cable your new system, consider these guidelines:
 Restricted access area: Install the system only in a restricted access area.
 Installation codes: This unit must be installed in accordance with the National Electrical
Code, Articles 110.16, 110.17, and 110.18 and the Canadian Electrical Code, Section 12.a
 Overcurrent protection: A readily accessible listed branch circuit overcurrent protective
device must be incorporated into the building wiring. For appropriate AWG rating of the
overcurrent protection device see NEC Table 310.16 and other national regulations.
 The protective bonding conductor depends on your power distribution topology. Make
sure that you use an appropriate protective bonding conductor regarding the rating of the
branch circuit protection.
 Install the system safely. Make sure that cables and cords are out of the way.
 Make sure that the set-up is comfortable for users.