Artesyn Centellis 4100 Installation and Use (2015) - Manual (Page 163)

Chapter 6
Centellis 4100 Installation and Use (6806800D82E) 165
Configuring and Operating the System
6.1 Overview
The following sections provide information that you need after you have successfully installed
the hardware.
Section Description
Network Management
on page 166 This section contains information on VLAN configuration,
slot numbering, IPMB and hardware addresses, and IP
addresses of ATCA-M100 and ATCA-F120.
Accessing System Components
on page
181
This section contains information on which component can
be accessed via which interface and where you can find
additional documentation.
Software
on page 182 This section contains information on which software is
installed on the system components and what tools can be
used for software upgrades.
Power Subsystem on page 186 This section contains information on power supplies and
power distribution.
Cooling Subsystem
on page 191 This section contains information on blowers, for example,
a block diagram.
Redundancy on page 194 This section contains information on cold standby, dual star
network topology and actions of shelf manager and system
manager during switchover, takeover, failover, insertion,
and extraction.
Blade Insertion and Extraction
on page 204 This section contains information about the steps carried
out by the software when a blade is inserted or supposed to
be extracted.
The information in the following subsections assumes that you have set the shelf address on both
ATCA-A100 alam boards to the same value via the rotary switches.