3 shelf configuration, Figure 5-6, Shelf configuration jumper settings – Artesyn Centellis 4100 Installation and Use (2015) User Manual

Page 162: Shelf configuration

Non-Field-Replaceable Units

Centellis 4100 Installation and Use (6806800D82E)

164

5.3

Shelf Configuration

Jumpers located at the back side of the system indicate the shelf configuration. Even though it
is possible to change the configuration settings via these jumpers, Artesyn Embedded

Technologies - Embedded Computing advises you not to do so. The jumpers for the A03 shelf

must remain set as shown in the figure below.

Figure 5-6

Shelf Configuration Jumper Settings

System Damage
Wrong jumper settings can make the shelf in-operable. Therefore, never change the
settings of the jumpers.

This manual is related to the following products:

AXP640 Installation and Use (April 2015) AXP1620 Installation and Use (August 2014) AXP1620 Installation and Use (September 2014) Centellis-4440/AXP-1440 Installation and Use (August 2014) Centellis-4440/AXP-1440 Installation and Use (July 2014) AXP1620 Installation and Use (May 2014) Centellis-4440/AXP1440 Installation and Use (August 2014) Centellis-4440/AXP-1440 Installation and Use (May 2014) Centellis-4440/AXP1440 Installation and Use (September 2014) AXP640 Installation and Use (May 2014)