Artesyn Centellis 4100 Installation and Use (2015) User Manual
Page 136
FRU Installation
Centellis 4100 Installation and Use (6806800D82E)
138
13.Install the feed cables to the connections on the PEM with the M6 nuts,
lockwashers and spring rings previously removed. Torque nuts to 3.8 Nm (33.63
lbf.in).
14.Pull the rubber boots over the nuts.
15.Once the new PEM is installed and connected, turn on the feed power.
PEM Damage
Applying reversal power causes damage to the electrolytic capacitors of the filter.
Therefore, only switch on the breakers if no red light is visible.
This manual is related to the following products:
- AXP640 Installation and Use (April 2015) AXP1620 Installation and Use (August 2014) AXP1620 Installation and Use (September 2014) Centellis-4440/AXP-1440 Installation and Use (August 2014) Centellis-4440/AXP-1440 Installation and Use (July 2014) AXP1620 Installation and Use (May 2014) Centellis-4440/AXP1440 Installation and Use (August 2014) Centellis-4440/AXP-1440 Installation and Use (May 2014) Centellis-4440/AXP1440 Installation and Use (September 2014) AXP640 Installation and Use (May 2014)