Artesyn Centellis 4100 Installation and Use (2015) - Manual (Page 107)

FRU Installation
Centellis 4100 Installation and Use (6806800D82E) 109
The switched off blue LED indicates that the blade`s payload has been powered up
and that the blade is active.
7. Connect cables to the face plate, if applicable.
4.2.2.2 Removing the Node Blade
This section describes how to remove the blade from an AdvancedTCA system.
After the blade has been inserted, you have to ensure that a boot image is either present on
the ATCA-F120 or on the blade’s hard disk.
Damage of Circuits
Electrostatic discharge and incorrect blade installation and removal can damage circuits or
shorten their life.
Before touching the blade or electronic components, make sure that you are working in an
ESD-safe environment.
Blade Malfunctioning
Incorrect blade installation and removal can result in blade malfunctioning.
When plugging the blade in or removing it, do not press on the face plate but use the
handles.