Artesyn Centellis 4100 Installation and Use (2015) - Manual (Page 18)

Centellis 4100 Installation and Use (6806800D82E)
About this Manual
18
About this Manual
Summary of Changes
Order No. Date Description
6806800D82A October 2007 Preliminary Installation and Use
6806800D82B February 2008 Deleted German translation of safety notes in text
Added
Figure "System Rear View" on page 51
Updated Ordering Information on page 63
Added Table "Critical Temperature Limits" on page 69
Added Figure "Hot Spot Air Inlet" on page 70 , Figure "Hot Spot Air
Outlet" on page 71 , and Figure "Hot Spot Power Entry Module"
on page 72
Updated Powering-Up the System on page 89
Added Before Installation on page 116
Updated Installing Power Entry Modules on page 126
Updated Installing Blowers on page 142
Updated chapter Chapter 6, Configuring and Operating the
System, on page 165
Editorial changes
6806800D82C July 2008 Added Figure "Declaration of Comformity" on page 62
Added Shelf Configuration on page 164
Changed heat dissipation values in Airflow Requirements on page
76 and Cooling Subsystem on page 191
Added Shelf Configuration on page 164
Corrected torque for feed cable connection
Replaced
Figure "PEM Location" on page 126 and Figure "Power
Entry Modules Location" on page 186
Replaced Figure "Block Diagram of a Blower" on page 193
Deleted all occurrences of SNMP
Deleted glossary
Editorial changes
6806800D82D July 2010 Corrected the wire size defined for the PEM power
wiring in
Requirements on page 81 and Installing the System in a
Rack on page 84
6806800D82E April 2015 Re-branded to Artesyn template.
Updated
Table 2-4 on page 73 .