Chapter 8, Frame 11 installation, Minimum mounting clearances – Rockwell Automation 20D PowerFlex 700H and 700S Frame 9-14 Drives Installation - A4 Size User Manual
Page 99: Minimum mounting clearances -1
Chapter
8
Frame 11 Installation
Most start-up difficulties are the result of incorrect wiring. Every precaution
must be taken to assure that the wiring is done as instructed. All information
in Chapter 1 “General Installation Information” and in this chapter must be
read and understood before the actual installation begins.
Minimum Mounting
Clearances
Figure 8.1 Enclosure Codes: A (NEMA/UL Type 1, IP21), M (NEMA/UL Type 1, IP21 w/
Conformal Coat), H (NEMA/UL Type 12, IP54) and W (NEMA/UL Type 12, IP54 w/
Conformal Coat)
!
ATTENTION: The following information is merely a guide for
proper installation. Rockwell Automation, Inc. cannot assume
responsibility for the compliance or the noncompliance to any
code, national, local or otherwise for the proper installation of
this drive or associated equipment. A hazard of personal injury
and/or equipment damage exists if codes are ignored during
installation.
200 mm
(7.87 in.) Min.
800 mm
(39.3 in.) Min.
Enclosure Code A (NEMA/UL
Type 1 - IP21) shown