Rockwell Automation 20D PowerFlex 700H and 700S Frame 9-14 Drives Installation - A4 Size - Manual (Page 214)

C-2 PowerFlex 700S Hi-Resolution (Stegmann) Encoder Feedback Option
SINCOS
®
, SINCODER
®
and LINCODER
®
are registered trademarks of Stegmann Inc.
Wiring the Hi-Resolution
Feedback Option Card to an
Encoder Terminal block P1 contains connection points for a Stegmann Hiperface®
encoder. This terminal block resides on the Hi-Resolution Encoder
Feedback Option card.
Hiperface® is a registered trademark of Stegmann Inc.
SINCOS
®
SRS660 1024 sine cycles per revolution Hollow-shaft up to 14 mm diameter
SINCOS
®
SHS-170 512 sine cycles per revolution. While the software supports this
encoder, the SHS-170 draws
excessive current and should only be
used with an external power supply.
Allen-Bradley 842HR 1024 sine cycles per revolution Has built-in mechanical turns
counter. IP65 Protection Class.
Size 25 square flange mounting.
Model Resolution Comment
Terminal Signal Description
12 POWER COMMON Power supply for encoder interface.
11 POWER
10 REFSIN Negative Sine signal.
9 +SIN Positive Sine signal.
8 REFCOS Negative Cosine signal.
7 +COS Positive Cosine signal.
6 SHIELD Connection point for encoder cable
shield.
5 SHIELD
4 N/C Not connected.
3 N/C
2 DATA+ (RS 485) Positive DH485 terminal.
1 DATA- (RS 485) Negative DH485 terminal.
TIP: Remember to route wires through the sliding access
panel at the bottom of the Control Assembly.
12
34
56
78
9
1
0
1
1
1
2