MacDon M205 Operators Manual User Manual
Page 99
Display (A)
Flashing
Alarm Tone
Description
ENGINE OIL PRESSURE
X
Continuous loud tone until oil
pressure is regained
Low engine oil pressure
ENGINE TEMPERATURE
X
Ongoing intermittent moderate
tone until temperature is below
215°F (102°C)
Engine temperature over 230°F
(110°C)
HEADER DISENGAGED
None
Normal
DISENGAGE HEADER
X
None
Header switch is in the ON
position when ignition switch is
turned ON
HEADER OIL PRESS
X
Continuous loud tone until oil
pressure is regained
Low header charge oil pressure
causes header to shut down:
header ON switch must be moved
to OFF position and then to ON
position to restart the header
HYDRAULIC FILTER
X
Single loud tone for 10 seconds:
repeats every 15 minutes until
condition is corrected
Excessive pressure increase
across hydraulic oil filter
### °C or F HYD OIL
COLD
X
Tone sounds with each flash for
5 seconds and then stops for
1 minute: flashing continues if
oil still cold after 1 minute, tone
sounds again
Hydraulic oil temp <50°F (10°C)
### °C or F HYD OIL HOT
X
Tone with each flash for 5
seconds at 220°F (105°C) then
tone stops for 1 minute while
flashing continues: if oil still
hot after 1 minute, tone sounds
again.
Flashing and steady tone at
temperatures of 230°F (110°C)
and higher
Hydraulic oil temp >220°F (105°C)
but <230°F (110°C)
IN PARK
X
One short beep
GSL in N-DETENT, steering
wheel centered, and brakes are
engaged
KNIFE SPEED
OVERLOAD
X
Short beep with each flash until
condition is corrected
Machine overload: knife or disc
speed drops below programmed
value
LOCK SEAT BASE
None
Seat base not detected in cab or
engine-forward position
LOW HYDRAULIC OIL
X
Continuous loud tone for 5
seconds: if condition not
rectified, single loud tone every
5 minutes
Low hydraulic oil level, header
shuts down automatically if
engaged: Header ON switch must
be moved to OFF position and
then to ON position to restart the
header
NO HEADER
None
Header is not detected
169887
83
Revision A