MacDon M205 Operators Manual - Manual (Page 141)

OPERATOR’S STATION
1. Turn ignition key to RUN, or start the engine. Refer to
Starting the Engine, page 152 .
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
Figure 3.159: CDM Programming Buttons
3. Press SELECT (B) until DIAGNOSTIC MODE? is
displayed in upper line.
• NO/YES is displayed on the lower line.
4. Press right (A) arrow to select Yes. Press SELECT (B).
Figure 3.160: Selecting Diagnostic Functions
5. Press SELECT (B) until FORCE HEADER TYPE? is
displayed on the upper line.
• NO/YES is displayed on the lower line.
6. Press right (A) arrow to select YES. Press SELECT (B).
• SELECT HEADER TYPE is displayed on the
upper line.
• DISK HEADER is displayed on the lower line.
Figure 3.161: Selecting Force Header Type
169887 125 Revision A