MacDon M205 Operators Manual - Manual (Page 334)

MAINTENANCE AND SERVICING
Changing Engine Oil
Refer to the following procedures:
• Checking Engine Oil Level, page 317
• Draining Engine Oil, page 318
• Replacing Engine Oil Filter, page 318
• Adding Engine Oil, page 319
Draining Engine Oil
DANGER
Stop engine and remove key from ignition before leaving operator's seat for any reason. A child or even a
pet could engage an idling machine.
NOTE:
The engine should be warm prior to changing the oil.
1. Stop the engine and remove the key.
2. Place a drain pan with a capacity of about 6 US gallons
(24 liters) under the engine oil drain.
3. Remove oil drain plug (A) and allow the oil to
completely finish draining.
4. Replace drain plug (A).
5. Check the condition of the used oil. If either of the
following is evident, have your Dealer correct the
problem before starting the engine:
• Thin black oil indicates fuel dilution
• Milky discoloration indicates coolant dilution
6. Dispose of used oil properly.
Figure 5.70: Engine Oil Drain Plug
Replacing Engine Oil Filter
NOTE:
Replace oil filter each time engine oil is changed.
1. Open the hood, refer to 5.4.1 Opening Hood (Lower
Position), page 288 .
169887 318 Revision A