MacDon M205 Operators Manual - Manual (Page 271)

OPERATION
Examples:
• Windrower is operating at 8 mph with header index ON and set at 1.5.
Display shows: 9.5 1.5 DRAP INDX where 9.5 (8 + 1.5) is the draper speed in mph and 1.5 is the
header index setting.
• Windrower speed drops to 7.5 mph at same header index setting.
Display shows: 9.0 1.5 DRAP INDX where 9.0 (7.5 + 1.5) is the draper speed in mph and 1.5 is the
header index setting.
• Windrower is operating at 8 mph with header index ON and set at 0.9.
Display shows: 8.9 0.9 DRAP INDX where 8.9 (8 + 0.9) is the draper speed in mph and 0.9 is the
header index setting.
Setting Draper Speed Independent of Ground Speed
Figure 4.222: Operator Console
Set the speed of the draper independent of ground speed as follows:
NOTE:
This procedure can also be used to change the draper speed “on the go”.
CAUTION
Check to be sure all bystanders have cleared the area.
1. Engage header.
2. Set HEADER INDEX switch (B) to OFF.
3. Press DISPLAY SELECTOR button (E) to show ##.# DRAPER SPEED on the cab display module (CDM) (A).
169887 255 Revision A