Checking and filling hydraulic oil, Warning, Danger – MacDon M205 Operators Manual User Manual
Page 399
WARNING
• Use a piece of cardboard or paper to search
for leaks.
• If ANY fluid is injected into the skin, it must
be surgically removed within a few hours by a
Doctor familiar with this type of injury or gangrene
may result.
Figure 5.198: Checking Hydraulic Leaks
IMPORTANT:
Foreign material such as dirt, dust, and water is the major cause of trouble in the hydraulic system.
If hydraulic system components must be disconnected for service, protect the ends of hoses, tubing, and ports of
components from contamination with clean, lint-free towels, or clean plastic bags.
Before installing any replacement hose, flush the inside with unused diesel fuel or unused commercial petroleum
cleaning solvent for ten seconds minimum. Do NOT use water, water soluble cleaners, or compressed air.
The hydraulic system components are built to very close tolerances and have been adjusted at the factory. Do
NOT
attempt to service these components except to maintain proper oil level, change oil and filters, and to
adjust relief pressures as described in this manual.
See your MacDon Dealer for all other service.
Checking and Filling Hydraulic Oil
Follow these steps to check and fill the hydraulic oil:
DANGER
Stop engine and remove key from ignition before leaving operator's seat for any reason. A child or even a
pet could engage an idling machine.
1. Park windrower on level ground and lower header and
reel so that lift cylinders are fully retracted.
2. Stop the engine and remove the key.
3. Open the hood, refer to
.
169887
383
Revision A