MacDon M205 Operators Manual - Manual (Page 119)

OPERATOR’S STATION
1. Turn ignition key to RUN, or start the engine. Refer to
Starting the Engine, page 152 .
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
3. Press right (B) arrow to select YES. Press SELECT (C).
• SET KNIFE SPEED? is displayed.
Figure 3.107: CDM Programming Buttons
4. Press SELECT (D) until HDR CUT WIDTH? #### is
displayed on the upper line.
• Previous cutting width is displayed on the lower line.
5. Press left (B) or right (C) arrows to change the headers
cut width. Press SELECT (D).
6. Press PROGRAM (A) to exit Programming Mode or
press SELECT (D) to proceed to next WINDROWER
SETUP action.
Figure 3.108: Setting Header Cut Width
Activating the Double Windrower Attachment (DWA)
NOTE:
• Follow this procedure if installing the DWA. For more information, refer to the DWA manual for proper installation
instructions.
• Follow this procedure if installing Drive Manifold (MD #139508).
169887 103 Revision A