5attaching and detaching headers, 1attaching a d-series header, Attaching and detaching headers – MacDon M205 Operators Manual User Manual

Page 218: Attaching a d-series header, 5 attaching and, 5 attaching, 5 attaching and detaching headers, 1 attaching a d-series header, Danger, Caution

4.5

Attaching and Detaching Headers

4.5.1

Attaching a D-Series Header

Refer to the procedure that is appropriate for the center-link installed on the windrower:

•

•

Attaching a D-Series Header: Hydraulic Center-Link with Optional Self-Alignment

NOTE:
This topic assumes that draper header boots have already been attached to the windrower lift linkage. If that is
not the case, refer to

To attach a D-Series header to a windrower equipped with a hydraulic center-link and optional self-alignment, follow
these steps:

DANGER

Stop engine and remove key from ignition before leaving operator's seat for any reason. A child or even a
pet could engage an idling machine.

1. Remove the hairpin (A) from pins (B) and remove the

pins from the header legs.

Figure 4.97: Header Leg

CAUTION

Check to be sure all bystanders have cleared the area.

2. Start engine and activate HEADER DOWN button (A)

on the ground speed lever (GSL) to fully retract header
lift cylinders.

Figure 4.98: GSL

169887

202

Revision A