5cab display module (cdm) programming, Cab display module (cdm) programming, 5 cab display module (cdm) programming – MacDon M205 Operators Manual User Manual
Page 101
3.18.5
Cab Display Module (CDM) Programming
Figure 3.67: CDM
A - Side Display
B - Main Display
C - Select Switch
D - Menu Item Scroll Forward
E - Menu Item Scroll Backward
F - Program Switch
SIDE DISPLAY:
displays software revision status.
• Upper Line – C### (CDM)
• Lower Line – X### (WCM)
MAIN DISPLAY
displays menu item and selection.
8
• Upper Line – Menu Item
• Lower Line – Selection
SELECT SWITCH
places monitor into Program Mode with PROGRAM switch. Press to accept menu item and
advance to next item.
MENU ITEM SCROLL FORWARD
displays value under menu item.
• Push to scroll forward
• Hold down for fast scroll
9
MENU ITEM SCROLL BACKWARD
displays value under menu item.
• Push to scroll backward
• Hold down for fast scroll
PROGRAM SWITCH
places monitor into program mode. Press while pressing SELECT switch.
8.
The current selection is flashing.
9.
Fast scroll applies only when changing KNIFE SPEED, OVERLOAD PRESSURE, and TIRE SIZE.
169887
85
Revision A