MacDon M205 Operators Manual - Manual (Page 122)

OPERATOR’S STATION
4. Press SELECT (D) until AUTO RAISE HEIGHT? is
displayed on the upper line.
• Last measurement is displayed on the lower line.
NOTE:
The auto raise height ranges from 4.0 (minimum) to 9.5
(maximum), in 0.5 increments. A setting of 10 disables
the auto raise function.
5. Press left (B) arrow or right (C) arrow to change
auto-raise height.
6. Press PROGRAM (A) to exit Programming Mode or
press SELECT (D) to proceed to next WINDROWER
SETUP action.
Figure 3.114: Setting Auto Raise Height
Displaying Reel Speed
NOTE:
• This procedure is for draper and auger headers. It does not apply to rotary disc headers.
• Header MUST be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header. For more information, refer to 4.5 Attaching and
Detaching Headers, page 202 .
1. Turn ignition key to RUN, or start the engine. Refer to
Starting the Engine, page 152 .
2. Press PROGRAM (A) and SELECT (C) on CDM to
enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
3. Press right (B) arrow to select YES. Press SELECT (C).
• SET KNIFE SPEED? is displayed on the upper line.
Figure 3.115: CDM Programming Buttons
169887 106 Revision A