8auto raise height, Programming the auto raise height feature, Auto raise height – MacDon M205 Operators Manual User Manual

Page 214: 8 auto raise height

4.4.8

Auto Raise Height

The header can be automatically raised if programmed into the cab display module (CDM).

Refer to the following topics:

•

•

Programming the Auto Raise Height Feature

Figure 4.89: Operator Console

A - Return to Cut

B - Program

C - Select

D - Right Arrow

E - Left Arrow

F - Header Up

G - Header Down

Program the AUTO RAISE HEIGHT feature as follows:

NOTE:
RETURN TO CUT switch (A) can be OFF or ON.

1. Press PROGRAM (B) and SELECT (C) on cab display module (CDM) to enter programming mode.

2. Press SELECT (C). WINDROWER SETUP? is displayed on upper line (B).

3. Press right arrow (D), then SELECT. SET KNIFE SPEED? is displayed.

4. Press SELECT (C) until AUTO RAISE HEIGHT is displayed.

5. Press left arrow (E) or right arrow (D) to change value on lower line. Working range is 4.0 to 9.5. At 10.0, the

feature is disabled and “OFF” is displayed.

6. When finished entering desired values, press PROGRAM to exit programming mode.

169887

198

Revision A