6cab display options, Setting the cab display language, Cab display options – MacDon M205 Operators Manual User Manual

Page 102: 6 cab display options

NOTE:
Contact your MacDon Dealer for information regarding software updates to the electronic modules. Your Dealer
will have the necessary interface tools and access to the latest software upgrades.

NOTE:
The following menus are available when ignition key is set to RUN:

• WINDROWER SETUP

• CAB DISPLAY SETUP

• DIAGNOSTIC MODE

The CALIBRATE SENSORS menu is available only when engine is running.

3.18.6

Cab Display Options

The display and sound features of the cab display module (CDM) can be adjusted to suit each particular Operator.

Setting the Cab Display Language

1. Turn ignition key to RUN, or start the engine. Refer to

Starting the Engine, page 152

2. Press PROGRAM (A) and SELECT (C) on cab display

module (CDM) to enter Programming Mode.

• WINDROWER SETUP? is displayed on the

upper line.

• NO/YES is displayed on the lower line.

Figure 3.68: CDM Programming Buttons

3. Press SELECT (B) until CAB DISPLAY SETUP? is

displayed on the upper line.

• NO/YES is displayed on the lower line.

Figure 3.69: Selecting Cab Display Setup

169887

Revision A