Changing the windrower display units – MacDon M205 Operators Manual User Manual

Page 103

4. Press right (C) arrow select YES. Press SELECT (D).

• DISPLAY LANGUAGE? is displayed on the

upper line.

• Default language is displayed on the lower line.

5. Press left (B) or right (C) arrow to select

preferred language.

NOTE:
English, Russian, and Spanish language options are
available on windrowers. Not all options are available on
all windrowers.

6. Press PROGRAM (A) to exit Programming Mode or

press SELECT (D) to proceed to next CAB DISPLAY
SETUP? action.

Figure 3.70: Selecting Display Language

Changing the Windrower Display Units

1. Turn ignition key to RUN, or start the engine. Refer to

2. Press PROGRAM (A) and SELECT (C) on cab display

module (CDM) to enter Programming Mode.

• WINDROWER SETUP? is displayed on the

upper line.

• NO/YES is displayed on the lower line.

Figure 3.71: CDM Programming Buttons

3. Press SELECT (B) until CAB DISPLAY SETUP? is

displayed on the upper line.

• NO/YES is displayed on the lower line.

4. Press right (A) arrow to select YES. Press SELECT (B).

• DISPLAY LANGUAGE? is displayed on the

upper line.

Figure 3.72: Selecting Cab Display Setup

169887

Revision A