MacDon M205 Operators Manual - Manual (Page 345)

MAINTENANCE AND SERVICING
Installing Primary Fuel Filter
IMPORTANT:
Do NOT prefill filter with fuel. Prefilling can contaminate the fuel system.
NOTE:
If replacing filter, refer to
Filter Part Numbers, page 286 .
1. Screw the new filter (A) onto the filter mount until the
gasket contacts the filter head.
2. Reconnect water in fuel (WIF) sensor (B).
3. Tighten the filter an additional 1/2 to 3/4 turn by hand.
IMPORTANT:
Do NOT use a filter wrench to install the filter.
Overtightening can damage the gasket and filter.
Figure 5.92: Fuel System
Removing Secondary Fuel Filter
1. Stop the engine and remove the key.
2. Open the hood, refer to 5.4.3 Opening Hood (Highest
Position), page 289 .
3. Clean around the secondary filter head (A).
4. Place a container under the filter to catch spilled fluid.
5. Remove filter (B) with a filter wrench.
6. Clean gasket mating surface.
Figure 5.93: Fuel System
Installing Secondary Fuel Filter
IMPORTANT:
Do NOT prefill filter with fuel. Prefilling can contaminate the fuel system.
169887 329 Revision A