MacDon M205 Operators Manual - Manual (Page 86)

OPERATOR’S STATION
Header Position Switches
Use the header position switches on the ground speed lever (GSL) to adjust the position of the header, relative to
the ground.
• To lower the header down, press switch (A)
• To raise the header up, press switch (C)
• To tilt the header down, press switch (B)
• To tilt the header up, press switch (D)
Release switch at desired position.
NOTE:
Refer to the section in this manual that is specific to your
header for detailed switch operating modes.
Figure 3.57: Ground Speed Lever
Reel and Disc Speed Switches
Press and hold switch (A) to increase the reel or disc speed.
Press and hold switch (B) to decrease the reel or disc
speed. Release switch at desired speed.
Auger Header
• A-30 header: Not applicable
• A-40 header: Auger speed is automatically maintained
when reel speed is changed
IMPORTANT:
Reel speed on auger header MUST NOT EXCEED
85 rpm. Auger speed MUST NOT EXCEED 320 rpm.
Figure 3.58: Ground Speed Lever
Draper Header
• Reel speed is limited in INDEX HEADER SPEED mode
Rotary Disc Header
• Conditioner speed automatically adjusts when DISC
SPEED is changed
169887 70 Revision A