Engine speed, Throttle adjustment – MacDon M205 Operators Manual User Manual
Page 365
3. Loosen compressor mounting hardware (B) and push
compressor towards engine to release tension.
4. Remove belt (A) from compressor.
5. Install new compressor belt (A).
6. Pry compressor away from engine so that a force of
8–12 lbf (35–55 N) deflects the belt (A) 3/16 in. (5 mm)
at mid-span.
7. Tighten compressor mounting hardware (B).
8. Recheck tension and readjust as required.
9. Close the hood, refer to
.
Figure 5.131: A/C Compressor
Engine Speed
The maximum and idle engine speeds are factory set.
Refer to
for detailed information. If specified speeds cannot be maintained, see your
MacDon Dealer.
Refer to
Engine Intermediate Speed Control (ISC), page 154
for information about engine speed.
Throttle Adjustment
The engine speed is controlled with the throttle lever that is connected to an electronic sensor inside the console.
The throttle lever in the cab should move the throttle sensor the full range between slow speed stop and full rpm
stop without contacting the console at either position.
If the throttle lever is contacting the console and interferes with specified engine speeds, the sensor position may
need adjustment. See your MacDon Dealer.
169887
349
Revision A