MacDon M205 Operators Manual - Manual (Page 387)

MAINTENANCE AND SERVICING
2. In the grill of the hood, remove two screws (A) from
light (B), and remove light.
3. Remove connector from light.
4. Connect wiring harness to new light (B) and install light
with screws (A).
Figure 5.176: Red Tail Lights
Replacing the Bulbs in Beacon Lights (if installed)
Beacon warning lights are available as an optional Dealer-installed attachment (MD #B5582).
DANGER
Stop engine and remove key from ignition before leaving operator's seat for any reason. A child or even a
pet could engage an idling machine.
To replace the halogen bulb inside the beacon warning
lights, follow these steps:
1. Shut down engine and remove key. Turn beacons OFF.
NOTE:
Hold onto the handholds (B) on the cab front
corners and stand on the header anti-slip strips,
or stand on the maintenance platform when
accessing the beacons (A).
Figure 5.177: Warning Beacons
169887 371 Revision A