MacDon M205 Operators Manual - Manual (Page 125)

OPERATOR’S STATION
4. Press SELECT (C) until SET ENGINE ISC RPM? is
displayed on the upper line.
• NO/YES is displayed on the lower line.
5. Press right (B) arrow to select YES. Press SELECT (C).
• PRESS HAZARD TO SET is displayed on the
upper line.
• ISC RPM #### is displayed on the lower line.
NOTE:
The previously selected ISC rpm will be flashing.
Figure 3.120: Set Engine ISC RPM
6. Press right (C) arrow to cycle between rpm options.
Press HAZARD (B) to set.
7. Press Select (D).
• EXIT ENGINE ISC? is displayed on the upper line.
• NO/YES is displayed on the lower line.
8. Press right (C) arrow to select YES. Press
SELECT (D).
9. Press PROGRAM (A) to exit Programming Mode.
Figure 3.121: Press Hazard to Set ISC RPM
3.18.9 Activating Cab Display Lock Outs
You can lock some of the header functions controlled by the cab display module (CDM) to prevent accidental
changes to header settings. You can use this feature to keep header settings constant when several different
operators use the windrower.
NOTE:
FUNCTION LOCKED flashes on CDM when locked header function switch is pressed.
Activating Knife Speed Control Lock Out
NOTE:
Header MUST be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header. For more information, refer to
4.5 Attaching and
Detaching Headers, page 202 .
169887 109 Revision A