MacDon M205 Operators Manual - Manual (Page 189)

OPERATION
Disconnect the center-link as follows:
13. To unlock the center-link, pull up on latch (A), and
position latch into notch (B) on top of hook.
14. Lift center-link off header pin.
NOTE:
If center-link self-alignment kit is installed, start
engine and raise center-link with the REEL UP
switch on the ground speed lever (GSL).
15. Slowly back windrower away from header, shut engine
OFF, and remove key from ignition.
Figure 4.43: Hydraulic Link
Attaching Header Transport Hitch to Header
Attach header transport hitch to header as follows:
1. Position end (A) of the aft section onto front wheel
hook (B).
2. Push down until latch (C) captures the end (A).
3. Secure latch (C) with clevis pin (D).
Figure 4.44: Transport Hitch
4. Remove the L-pin from end (A) of aft section
(if installed).
Figure 4.45: Transport Hitch
169887 173 Revision A