MacDon M205 Operators Manual - Manual (Page 104)

OPERATOR’S STATION
5. Press SELECT (D) until DISPLAY UNITS? is displayed
on the upper line.
• Default setting is displayed on the lower line.
6. Press left (B) or right (C) arrow to select either METRIC
or IMPERIAL speed display.
7. Press PROGRAM (A) to exit Programming Mode or
press SELECT (D) to proceed to next CAB DISPLAY
SETUP? action.
Figure 3.73: Selecting Display Units
Adjusting the Cab Display Buzzer Volume
1. Turn ignition key to RUN, or start the engine. Refer to
Starting the Engine, page 152 .
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
Figure 3.74: CDM Programming Buttons
3. Press SELECT (B) until CAB DISPLAY SETUP? is
displayed on the upper line.
• NO/YES is displayed on the lower line.
4. Press right (A) arrow to select YES. Press SELECT (B).
• DISPLAY LANGUAGE? is displayed on the
upper line.
Figure 3.75: Selecting Cab Display Setup
169887 88 Revision A