1attaching header boots, 2header position, Attaching header boots – MacDon M205 Operators Manual User Manual
Page 264: Header position, 1 attaching header boots, Caution, 2 header position
4.6.1
Attaching Header Boots
Header boots are required to attach a D-Series Draper Header to the windrower.
CAUTION
To prevent damage to the lift system when lowering
header lift linkages without a header or weight box
attached to windrower, ensure that float engagement
pin is installed in storage location (B) and NOT
installed at hole location (A).
Figure 4.213: Header Lift
If NOT installed, attach draper header boots (supplied with
header) to windrower lift linkage as follows:
1. Remove pin (B) from boot (A).
Figure 4.214: Header Boot
2. Position boot (B) on lift linkage (A) and reinstall pin (C).
Pin may be installed from either side of boot.
3. Secure pin (C) with hairpin (D).
4. Repeat for opposite side.
Figure 4.215: Header Boot
4.6.2
Header Position
Refer to
4.4 Operating with a Header, page 182
for procedures for controlling header height, header tilt, and float.
169887
248
Revision A