MacDon M205 Operators Manual - Manual (Page 187)

OPERATION
DANGER
To avoid bodily injury from fall of raised header, always engage safety props when working on or around
raised header, and before going under header for any reason.
1. Set header on the ground (field position).
2. Disconnect the following hydraulic and electrical
connections:
a. Left Side – Store hydraulic hoses and electrical
cable into the storage position. Refer to header
operator’s manual.
b. Right Side – Release the multi-link and place
into storage on windrower. Refer to header
operator’s manual.
3. Retrieve temporary lift pin from storage location on
weight box and install into rear hole (A) at the top
of the lift arms. This provides additional lift height for
transport wheel deployment.
CAUTION
Check to be sure all bystanders have cleared the area.
4. Start engine and raise header to full height.
5. Stop engine and engage safety props on lift cylinders.
Figure 4.38: Lift Arms
6. Deploy header slow speed transport system. Refer to
header operator’s manual.
Figure 4.39: Header in Transport Mode
169887 171 Revision A