MacDon M205 Operators Manual - Manual (Page 421)

MAINTENANCE AND SERVICING
Removing Formed Caster Wheel
1. Raise caster wheel, refer to Raising Caster Wheel
(Formed and Forked), page 402 .
2. Remove the six bolts (A) that secure the wheel (B) to
the hub.
3. Remove wheel (B).
Figure 5.235: Caster Wheel Assembly
Installing Formed Caster Wheel
1. Position wheel assembly (B) on hub, and install the six
wheel bolts (A).
2. Torque bolts (A), refer to Tightening Caster Wheel
Nuts, page 401 .
3. Lower caster wheel, refer to Lowering Caster Wheel
(Formed and Forked), page 403 .
Figure 5.236: Caster Wheel Assembly
Tightening Caster Wheel Anti-Shimmy Dampeners
Each caster is equipped with a fluid-filled anti-shimmy
dampener (A).
The mounting bolts (B) need to be checked periodically for
security. Refer to
5.7.11 Maintenance Schedule, page 407 .
• Inboard bolt should be tightened to 100 ft·lbf (135 N·m)
• Outboard bolt should be tightened to 85 ft·lbf (115 N·m)
Figure 5.237: Anti-Shimmy Dampener
169887 405 Revision A