MacDon M205 Operators Manual User Manual
Page 438
Symptom
Problem
Solution
Section
Broken pump arm or shaft
Contact Dealer.
Contact Dealer.
One final drive disengaged
Engage final drive.
Steering controls worn or
defective
Check GSL and steering for loose,
worn or damaged ball joints and
connecting rods.
5.7.3 Ground
Speed
Lever (GSL)
Adjustments,
page 299
and
5.7.4 Steering
Adjustments, page
301
High pressure relief valve
stuck open, damaged seat
Check valve, and clean or replace.
Contact Dealer.
Brakes binding or not
releasing fully
Check pressure on brake release
valve) (min. 200 psi [1379 kPa]).
Damaged hydraulic lines
preventing proper oil flow
Ground speed range control
not working
One wheel does
not pull in forward
or reverse
Failed pump, motor or power
hub
Contact Dealer.
Contact Dealer.
Mechanical interference in
steering or ground speed
linkage
Adjust, repair, replace.
5.7.3 Ground
Speed
Lever (GSL)
Adjustments,
page 299
and
5.7.4 Steering
Adjustments, page
301
Brakes binding or not
releasing fully
Check pressure on brake release
valve) (min. 200 psi [1379 kPa]).
Faulty pump or motor
Contact Dealer.
Contact Dealer.
Air in system
Check lines for leakage.
Excessive noise
from drive system
Hydraulic line clamps loose
Tighten clamps.
—
Not properly tightened
Tighten filter element.
Hydraulic oil filter
leaks at seal
Damaged seal or threads
Replace filter or filter head.
169887
422
Revision A