MacDon M205 Operators Manual - Manual (Page 333)

MAINTENANCE AND SERVICING
Engine Oil
Checking Engine Oil Level
Check engine oil level frequently and watch for any signs of leakage.
To check the engine oil level, follow these steps:
NOTE:
During the break-in period, a higher than usual oil
consumption should be considered normal.
1. Open the hood to the lowest position. Refer to 5.4.1
Opening Hood (Lower Position), page 288 .
2. Operate the engine at low idle and check for leaks at
the filter and drain plug.
3. Stop the engine and remove the key. Wait about
5 minutes.
4. Remove the dipstick (A) by turning it counterclockwise
to unlock.
5. Wipe the dipstick clean and reinsert it into the engine.
6. Remove the dipstick again and check the oil level.
Figure 5.68: Engine Oil Level
7. Oil level should be between LOW and HIGH. If level is
below LOW mark, 2 US quarts (1.9 liters) will raise the
level from LOW to HIGH.
NOTE:
If you need to add oil, refer to
Adding Engine Oil, page
319 .
8. Replace dipstick and turn it clockwise to lock.
9. Close the hood, refer to 5.4.4 Closing Hood (Highest
Position), page 290 .
Figure 5.69: Engine Oil Level
169887 317 Revision A